• Arredondo Shell Stabilizer

click on thumbnail to zoom

Arredondo Shell Stabilizer

Other products by Arredondo

Item #: D
Reg. Price: $19.95
Our Price: $19.95


Increase your load productivity by adding efficiency and confidence using the Arredondo Shell Stabilizer.

The stabilizer will add control for powder compaction and bullet insertion.

The shell stabilizer is easy to install, first remove the two locator button pins and simply insert the stabilizer in place.


Average Rating:
(based on 6 reviews)

Showing 1 - 5 of 6 Reviews:

by Flywheel
on 8/6/2020
Super fast delivery. Great products as well.
by Hogrider
on 6/18/2020
Shell Stabilizer
This item does a good job of stabilizing the cases; word of advise:  make sure that your seating die does not initially install against the shell plate.  If so, the die bottom with destroy the stabilizer.  Don't ask me how I know this!  
by BrianW
on 3/20/2020
Had Higher Hopes
It's a piece of plastic with a rubber bumper.  I guess I thought it was a piece of metal with a rubber bumper.  I had to trim the rubber piece because it tilted the casings inwards and caused my MBF to stop dropping consistently.  It does seem to help a little with powder spillage.  I probably wouldn't buy it again though.
by Brandon
on 6/26/2019
from greenville
worth it.
loading 9.6 grains in 9mm, my press is just as clean and free of spilt powder after 500rds as when I started.  occasionally one side lifts up an 1/8th of an in and I have to press it back down. 
by Lee
on 4/11/2019
from Lecanto
worked for me
I use red dot and a mk7 on my 1050.  this works better than the zip tie hack.  I use a full-length seating die and some of the rubber is gone where the die meets the shell plate but it still works well
Review and Rate this Item

Top Sellers