Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.831"
Overall Width: 1.062"
Dovetail Width: .253"
Mounting Hardware: (2) 8-32 Button Head Screws, (1) 8-32 Set Screw)
Red Dot Fitment: Vortex Razor, C-More RTS & STS
This mount fits all generation Glocks with only rear sight dovetail cuts:
(including but not limited to)
Glock 17
Glock 17L
Glock 19
Glock 19x
Glock 20
Glock 21
Glock 22
Glock 23
Glock 24
Glock 26
Glock 27
Glock 29
Glock 30
Glock 30 SF
Glock 31
Glock 32
Glock 33
Glock 34
Glock 35
Glock 36 (Our mount is wider than the slide, but it will still work)
Glock 37
Glock 38
Glock 39
Glock 41
Glock 42 (Our mount is wider than the slide, but it will still work)
Glock 43 (Our mount is wider than the slide, but it will still work)
Glock 43x (Our mount is wider than the slide, but it will still work)
Glock 44
Glock 45
Glock 46
Glock 48 (Our mount is wider than the slide, but it will still work)
Canik TP9SF
Bersa BP9CC
Tactical Solutions .22lr Conversion
Advantage Arms .22lr Conversion
PSA Dagger (non-optics ready)
Does not fit ANY/ALL Glock MOS models.
Does not fit ANY/ALL Glock slides that are already cut for optics.
This mount will also fit the NON-optics ready PSA DAGGER
Our Glock sights are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
The screws that are included with this mount require a 5/64'' allen wrench for installation.
